鄂尔多斯附近有没有服务

News Center

Current location: home page  >  News Center

Technical parameters single air shower single double air shower

The environmental requirements of industrial manufacturing only increase but not decrease. The quality of manufacturing environment is not only closely related to the health of staff in production activities, but also related to the level of production power, product quality, and even the development and production process can be carried out. The cleaning technology of double air dryer is the basis of pollution control and prevention. This product is not sensitive to contamination.

  7。 The emergency stop switch can cut off the power supply immediately and make all doors of the air shower room open in case of failure.

  5。 Filter screen: primary filter and high-efficiency filter are used to filter two-stage filtration, and the filtration efficiency can reach 99. 99% (sodium flame method) dust particle size ≥ 0. 5μm。

It can be widely used in the double room of the factory. At the same time, it also acts as a buffer for airflow. How to maintain the double blower and shower room correctly is as follows: the temperature should be controlled below 50 ℃ in the steps of use. In addition, open fire is strictly prohibited. Second, the single person and double air dryer should check the technical indicators of the equipment regularly and timely handle the failure to meet the requirements. Thirdly, the door of double air dryer should be maintained regularly to avoid door sticking. Fourth, if the wind speed changes, check whether the surface of the air filter is blackened at * * time. However, if there is too much dust accumulated in the filter container and the blockage area is large, leading to ventilation, the non-woven fabric of the filter should be removed for replacement or cleaning. Fifthly, before replacing the high-efficiency filter in the air shower room, first remove the spray ball plate and then take out the filter. However, it must be noted that the specifications and models of the replaced high-efficiency filter must be exactly the same as the original one. The installation should be carried out according to the mark on the arrow of high efficiency filter, because the arrow points to the direction of air flow. In addition, ensure that the double air dryer is well sealed to prevent leakage. Sixth, after the installation of the high efficiency filter, the dust particle counter should be used for detection, which can work normally only after reaching the index requirements. Seventh, the filter material in the filter should be cleaned and protected regularly. Eighth, regular detection of electrical circuits.

Material: with industrial aluminum, stainless steel square, iron square as the frame is stable. b. Good anti-static, anti-static, anti-static, anti-static, anti-corrosion, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti-static, anti Protection, small vibration, stepless speed change and other characteristics, reliable quality of the fan, long working life, coupled with the unique air duct research and development, greatly improve the power level of the fan, compared with the noise! f。 Product preparation simple dust-free room focuses on: A, the purification level can reach 100-100K level; it is very suitable for the local purification level requirements in the workshop, such as assembly line operation area.

Stainless steel air shower room is a personal purification device used by operators when entering the clean room. It uses high-speed clean air to blow and drench away the dirt from the people entering the room. When the staff enter the air shower room, the automatic voice controller will prompt you to complete the whole shower process. The nozzle can be adjusted so as to effectively remove dust from people and prevent external pollution from entering the clean area. It can also be used for large goods. With the use of the stopper, it can realize the continuous, rhythmic operation, accumulation and use of the product; with the lifting and translation device, it can realize the offline repair or detection of the product without affecting the operation of the whole assembly line. Flash point of belt type assembly line: the load-bearing products are extremely light and the shape limit is less; the single air shower room can realize the climbing and turning of the products when running synchronously with the manufacturing line; the belt can be used as the carrier and conveying to realize the stable transportation of products with low noise; the light materials or products can be transported over a long distance. Flash point of differential conveying line: double speed chain traction is adopted in differential conveying pipeline, tooling board can be transported freely, blocking device is used to position workpiece to move or stop freely, and workpiece can be automatically lifted and moved horizontally at both ends. It should also be online.) , special aircraft, testing equipment, manipulator and other devices. Single air shower!

Third, the single air shower time factor, the single air shower should be more than 30 seconds, especially small particles of dust. At present, the single air shower on the market can set the time of shower freely. 4、 The noise factor of single air shower room is due to the high-speed airflow and fan inside.

Stainless steel air shower room is composed of box, stainless steel door, coarse efficiency filter, high efficiency filter, fan, static pressure box, nozzle interlock controller, operation panel, induction device, etc.

  8。 Induction control system: infrared induction shower, PLC control, LED display shower time, shower time can be set to 5s-99s, factory initial shower time is generally set to 15 seconds, touch type micro switch.

With the continuous advancement of social industrialization, air pollution is accompanied by the emergence of people's air cleanliness requirements are also rising. Many people still don't know much about the air purification technology such as air shower, but it is the automatic induction door. The air shower room plays a very good role in people's life. The single air shower room can remove the sundries carried by the staff and prevent the dust from being brought to the workplace, so as to make the workplace pollution-free and ensure the health and safety of the products manufactured. The air shower room of automatic induction door is installed in two spaces, one of which is clean and the other is not clean. Therefore, people walking in these two spaces may be able to pass through the wind shower room and blow away bacteria and dust on their bodies through the wind, thus creating a clean and comfortable environment.

  10。 Equipped with large air volume and low noise centrifugal fan, the wind speed can reach 20 ~ 25m / s, providing high efficiency jet for effective cleaning dust.


Last article: How often does the filter change the air in the air shower

Last article: Door manufacturer air shower

Recommended products

What's new